Display issue
Posted: Sat Aug 10, 2019 7:27 pm
Before I do any actions with this software, I would like an advise, is it up this alley.
So heres the situation: Just installed fresh windows10, generic monitor, generic display adapter. Have two monitors: Benq XL2411T (144hz, on cable DVI - DVI), Benq GL2460 (DVI monitor - HDMI gpu). On fresh w10, generic drivers only one monitor works, obviously, because only one is detected.
But then this happens: w10 installs gtx970 display driver and both monitors (I hear it with windows sound). As soon as this happens, my second monitor Benq GL2460 turns on, while first monitor BenQ XL2411T turns off showing "No Signal Detected!". Device manager shows monitor driver installed, NVIDIA Control Panel also shows it detected, and my resolution is also shares width with 2 monitors, it just goes into black hole of monitor with "no signal".
Interesting detail is that monitor, which is "no signal" on NVIDIA Control Panel is showed to use VGA connector, which is false its on DVI - DVI, with DVI capture mode. Also If I swap the cables of monitors, they swap their working/not working status too, just first one cannot reach 144hz with HDMI cable.
So yeah, here's the situation, any help appreciated.
So heres the situation: Just installed fresh windows10, generic monitor, generic display adapter. Have two monitors: Benq XL2411T (144hz, on cable DVI - DVI), Benq GL2460 (DVI monitor - HDMI gpu). On fresh w10, generic drivers only one monitor works, obviously, because only one is detected.
But then this happens: w10 installs gtx970 display driver and both monitors (I hear it with windows sound). As soon as this happens, my second monitor Benq GL2460 turns on, while first monitor BenQ XL2411T turns off showing "No Signal Detected!". Device manager shows monitor driver installed, NVIDIA Control Panel also shows it detected, and my resolution is also shares width with 2 monitors, it just goes into black hole of monitor with "no signal".
Interesting detail is that monitor, which is "no signal" on NVIDIA Control Panel is showed to use VGA connector, which is false its on DVI - DVI, with DVI capture mode. Also If I swap the cables of monitors, they swap their working/not working status too, just first one cannot reach 144hz with HDMI cable.
So yeah, here's the situation, any help appreciated.