Wagnardsoft Forum

Wagnard wrote: ↑Sun May 29, 2022 1:37 pm There is a question quite obvious I didn't ask you...
Windows 10 or Windows 11 ?

I updated with the experimental fix: https://www.wagnardsoft.com/ISLC/ISLC%20v1.0.2.8.exe

Wagnard wrote: ↑Sun May 29, 2022 1:37 pm There is a question quite obvious I didn't ask you...
Windows 10 or Windows 11 ?

I updated with the experimental fix: https://www.wagnardsoft.com/ISLC/ISLC%20v1.0.2.8.exe

vmech wrote: ↑Wed Jun 01, 2022 4:06 am This version is even less workable than previous one. Symptoms and behavior are the same, except that after manually pressing Start/Stop button, purging does not occur. At all. A full program restart is required.

vmech wrote: ↑Wed Jun 01, 2022 4:18 am

vmech wrote: ↑Wed Jun 01, 2022 4:06 am This version is even less workable than previous one. Symptoms and behavior are the same, except that after manually pressing Start/Stop button, purging does not occur. At all. A full program restart is required.

And after program restarting purging does not work... Very strange.
Also, purging does not work when conditions are met. Only if you force the purging to start with «Purging» button.
Latest version is unusable. I rolled back to the previous 1.0.2.8.

Wagnard wrote: ↑Wed Jun 01, 2022 4:52 pm Thanks, its possible there is a mistake somewhere, I made a lot of changes.it sure is weird that even after program restarting it doesn't work. Double check the values you entered. I'll do some check on my end too.
Exception was at 0 when it didn't want to purge?

vmech wrote: ↑Wed Jun 01, 2022 7:49 pm

Wagnard wrote: ↑Wed Jun 01, 2022 4:52 pm Thanks, its possible there is a mistake somewhere, I made a lot of changes.it sure is weird that even after program restarting it doesn't work. Double check the values you entered. I'll do some check on my end too.
Exception was at 0 when it didn't want to purge?

I don't touch configuration file, I update only .exe/.pdb files (just extracting files from sfx-archive in FAR ).
Damn, I didn't remember status of counter at the time of failure. But after program restarting the counter was definitely at 0.

Wagnard wrote: ↑Sat Jun 04, 2022 9:44 am I found the problem, it was from the way I compiled my code.
You can download the file again, it will be working correctly this time.

https://www.wagnardsoft.com/ISLC/ISLC%20v1.0.2.8V2.exe

Wagnard wrote: ↑Sat Jun 04, 2022 9:44 am I found the problem, it was from the way I compiled my code.
You can download the file again, it will be working correctly this time.